Disconnect the NEG (-) battery terminal. Disconnecting power from your vehicle may allow the computer to “clear” its memory during installation. Loosen and remove bolts from flange.
Remove stock system from rubber hangers keeping in mind that it may be necessary to cut the stock system just behind the muffler for easy removal.
Install muffler using stock rubber hangers. Do not tighten anything until the entire system is in place. This includes the overlapping tabs on the tail pipes. The driver side tail pipe tab should sit on top of the passenger side tab.Once system is in place, start tightening the bolts and the clamp at the front and work your way back tightening the remaining clamps. Tighten the flange evenly. Once the flange is pulled up evenly and it is sealed around the ball. Make sure tips are aligned before tightening the rear clamp.
It is normal for stainless steel to discolor slightly. To ensure a quality, lasting finish, thoroughly wipe down the entire system before starting. Reconnect the battery NEG (-) terminal. Start vehicle.
With the vehicle running at an idle, check for exhaust leaks at each connection. If there is a leak, check that the mounting hardware is tight.
© 2011 - Billy Boat Performance Exhaust® and the B&B® logo are trademarks. All rights reserved.